Adult / youth 9″ x 8.5 ” sublimation blank Beanie Cap 100% polyester – Two polyester layer black inner – Lay Flat- Wholesale

Sublimation blank beanie cap features

• H 8.5″ x W 9″;
• 100% sublimation polyester material for high quality image printing;
• Double side 100% polyester sublimation beanie;
• Inside black polyester layer;
• Stretchable sublimation fabric;
• Contact us for template and support for sublimation process;
• Full sublimation printing services is available with us.

Shipping:

• All orders ship the same day.
• Rush overnight shipping available at extra cost.
• Call us at (703)880-8230 for all rush requests.

Sublimation tips for printing on sublimation pillow case :

Most sublimation fabrics items are handmade and sizing may vary. Please check size of each item for any variation while creating the sub design.

Use lint roller to clean the print area before pre press to remove any loose fibers.

We found the best results are achieved using a soft press pillow pad under the ties so that the sublimation area gets most contact with the press and edges.

Here is link to press pillow if you do not have one :  https://www.amazon.com/s?k=transfer+pillow.

Temperature and time depends on Ink and paper, These pillowcases are sublimated best at 400 f for 60-80 seconds. We recommend Medium-Pressure for logos with no bleed and medium-high pressure for artwork with full bleed. Make sure no wrinkles when pre pressing, spread out the fabrics or tape down if any and pre press again. Place your print on the sublimation beanie cap.  Always design and cut the sub paper so it is bigger then beanie. I have found this guide to be quite useful in sublimation  found at https://www.myenmart.com/Dye_Sublimation_Guide.pdf